New platforms have been sealed and finished with an oil-based,
wood preservative by the manufacturer. Platforms will keep the new
look and last for many, many years if properly maintained. For best
results re-oil the platform and allow it to dry before the first use. If
the boat spends a lot of long weekends on the lake with the swim
platform in the water or if the platform sits uncovered in the sun, it
should be oiled one or two times a month during the first season;
then as needed after that. The platform should be covered when not
in use or when stored for the winter.
Many products such as boiled linseed oil, tongue oil, wood oil and
other outdoor wood preservatives can be found at marinas, paint
stores or home improvement stores. Some oils such as linseed oil
should be thinned with a thinner like mineral spirits before use. (70
percent oil-30 percent thinner.)
When oiling a platform, apply a coat of oil with a wet cloth, work into
the seams, end grain and edges. Allow the oil to set approximately
15 minutes and then wipe off the excess oil with a dry cloth.
Do not let the oil dry on the platform in the sun. Excess oil should be
removed with a dry cloth.
Troubleshooting
If at any time the swim platform does not feel secure (there should
be no noticeable movement or “play” in relation to the rest of the
boat), immediately leave the swim platform. Verify that, whether
permanently attached or held in place with brackets, the platform is
fastened as designed. If it is not, stop using the swim platform and
take the boat to an authorized MasterCraft dealer for repair.
SKI RACKS
Models
ProStar, as an option.
Purpose
The ski racks provide a sleek and attractive method to store skis in
the gunwales on both sides of the boat interior. These ski racks are
constructed with anodized aluminum and particular attention must
be paid to prevent corrosion. See Corrosion in the Care and Mainte-
nance section of this Owners Manual.
To Next Page
Loading...
Need help?
General
