10
August 1999 / MASS battery charger / EN
GENERAL INFORMATION
/ SAFETY GUIDELINES EN MEASURES
1 GENERAL INFORMATION
GARANTEE SPECIFICATIONS
Mastervolt quarantees the performance of this Mass char-
ger according to the specifications given in the data
sheets, if installed and used as described in this manual.
Should work take place, which is not in accordance with
the guidelines, instructions and specifications contained
in this user's manual and the supplementary installation
manual, then damage may occur and/or the unit may not
fulfil its specifications. All of these matters may mean that
the guarantee may become invalid.
The guarantee period is two years.
QUALITY
During their production and prior to their delivery, all of our
units are exhaustively tested and inspected.
LIABILITY
Mastervolt can accept no liability for:
• damage due to use of the battery charger;
• possible errors in the manual and the results thereof.
2 SAFETY GUIDELINES & MEASURES
USE FOR INTENDED PURPOSE
The battery charger is contructed as per the applicable
safety-technical guidelines. Use the battery charger only:
• for the charging of lead acid batteries and the supply of
users attached to these batteries, in permanent sys-
tems;
• connected to a dedicated double pole circuit breaker
(MCB);
• with a fuse, protecting the wiring between charger out-
put and battery;
• in a technical correct condition;
• in a closed, well-ventilated room, protected against rain,
moist, dust and not condensing circumstances.
Never use the battery charger at locations
where there is danger of gas- or dust explo-
sion!
Use other than as mentioned under 2 is not considered to
be consistent with the intended purpose. Mastervolt is not
liable for any damage resulting from the above.
SAFETY
1 Use only fuses with the prescribed current level:
• AC supply fuse not greater than is required for the
current consumption;
• The charger fuse must be large enough for the ma-
ximal charger current and small enough to protect
the charger‘s output cables.
2 Check the wiring at least once a year. Defects such as
loose connections, burned cables etc. must be correc-
ted immediately.
3 Do not work on the charger or the system if it is still
connected to a current source. Only allow changes in
your electrical system to be caried out by qualified
electricians.
4 Connection and protection must be done in accor-
dance with local standards.
5 Before opening the cabinet of the charger, switch off
the 230V mains and remove the charger fuse.
MAINTENANCE & REPAIR
If the battery charger is switched off during maintenance
and/or repair activities, it should be secured against unex-
pected and unintentional switching on:
• switch off the AC circuit breaker;
• disconnect the charger;
• switch off the connection with the batteries or remove
the charger fuse;
• be sure that third parties cannot reverse the measures
taken.
If such are required, use only original spare parts.
To Next Page
Loading...
Need help?
General
