EasyManua.ls Logo

Mastervolt MASS 12/30-2 - Operating the Charger; Tips for Battery Lifetime

Mastervolt MASS 12/30-2
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
14
August 1999 / MASS battery charger / EN
INSTALLATION
/ OPERATION / USING THE CHARGER WITH YOUR BATTERIES
Forced float
For industrial applications only.
Gel/wet battery
By removing this jumper the output will be a constant
“trickle charge” voltage of 13,8V.
Diode compensation
By removing this jumper the output voltage will be increased
with 0,7 Volt.
6 OPERATION
1 Check if the charger is „OFF”.
2 Connect DC output with batteries or place fuse.
3 Switch on AC source.
Switching on:
The MASS charger will be switched on by the ON switch.
One of the front LEDS will light up now and the charging
starts immediately.
INDICATOR LIGHTS
FLOAT:
The battery charger is
in a “trickle charge” mo-
de, batteries are 100%
charged.
ABSORPTION
:
The batteries are still
charging, charge level
is approx. 80%.
BULK:
The charger supplies
the maximal voltage,
the battery charge is
less than 80%.
Switching off:
The IVO charger will be switched off by the OFF switch.
7 USING THE CHARGER WITH YOUR
BATTERIES
CHARGING EFFICIENCY
For a good performance your batteries should not be
discharged below 30-40% of their capacity. Therefore al-
ways start charging at this level.
As in marine and mobile systems often a limited charging
time is desired, batteries are with generator use charged
up to 85-90%. Charging up to 100% would take too long.
This means that normally about 50% of the theoretical
battery capacity can be used.
In case a mains connection is present, charging time is
less important. Then charging up to 100% is advised.
TIPS TO INCREASE THE BATTERY LIFETIME:
Install the batteries at a cool place. The acid in the bat-
teries will damage the plates in a high temperature en-
vironment. A normal life time of 5 year at 20°C, will go
down to 2.5 years at 30°C.
Charge the battery immediately after a consistent deep
discharge.Especially at high environment temperatures,
sulfating occurs very fast. If the state of sulfating is not
too bad, the battery will regain a part of its capacity af-
ter a number of charge/recharge cycles.
bulk charge - on
absorption 50 %
float charge 80 - 100 %
CHARGE INDICATOR
off
on
charge failure
MASS
AUTOMATIC
BATTERY CHARGER

Related product manuals