Mateksys F722-SE - User Manual

Nov.2018 Rev 1.0 www.mateksys.com
FLIGHT CONTROLLER F722-SE
BASIC MANUAL
MCU: 216MHz STM32F722RET6
IMU: MPU6000 & ICM20602, Dual Gyros built-in
Baro: BMP280
OSD: AT7456E
Blackbox: MicroSD card slot
5x Uarts (1,2,3,4,6) with built-in inversion
1x Softserial supported
8x Dshot/Proshot/oneshot outputs
1x I2C
4x RX6 pads for BLheli32 ESC telemetry
4x individual ESC power/signal pads
1x Group of G/S1/S2/S3/S4 pads for 4in1 ESC Signal/GND
Vbat filtered output power for VTX, switchable via AUX (modes tab-user1)
Dual Camera image switchable via AUX (modes tab-user2)
Camera control
Smartaudio & Tramp VTX protocol
WS2812 Led Strip
Beeper
RSSI
INAV analog airspeed
Input: 6~36V (3~8S LiPo)
PDB: 4x35A (Max.4x46A)
BEC: 5V 2A cont. (Max.3A)
LDO 3.3V: Max.200mA
Current Sensor 184A (Scale 179)
Battery Voltage Sensor: 1:10 (Scale 110)

Summary

Flight Controller F722-SE Features

Core Components

Details MCU, IMU, Baro, and OSD specifications.

Connectivity and Outputs

Lists Uarts, Softserial, Dshot outputs, I2C, and ESC pads.

Power and Control Features

Input Power and PDB

Configuration and Setup

Target Firmware Selection

Specifies the target for BetaFlight and INAV firmware.

Gyro Swapping (BetaFlight)

Instructions for selecting the primary gyro in BetaFlight.

Gyro Swapping (INAV)

Instructions for selecting the primary gyro in INAV.

VTX and Camera Switching

Mateksys F722-SE Specifications

General

Processor	STM32F722RET6
CPU Speed	216 MHz
RAM	512 KB
Gyroscope	BMI270
Accelerometer	BMI270
OSD	Yes
UART Ports	6
PWM Outputs	8
I2C Ports	2
SPI Ports	1
Dimensions	36 x 36 mm
Mounting	30.5 x 30.5 mm
Motor Outputs	4
BEC	5V 2A
Input Voltage	3-6S LiPo
Firmware	Betaflight