20 Matrix PRASAR UCS Quick Start
Configuring SIP Trunks
SIP trunks may be Proxy or Non-Proxy. All SIP trunks are considered as Proxy trunks by default.
Regardless of whether a SIP Trunk is Proxy or Non-Proxy, it must be assigned to the LAN/WAN
Port, which is to be used for that SIP trunk and the SIP trunk must be enabled. VoIP Calls can be
initiated after suitable configuration of the SIP trunk number in the Outgoing Trunk Bundle Group.
Refer to the PRASAR System Manual for detailed instructions.
For Proxy SIP Trunks, you must configure the following parameters required for registration with
the Proxy Server.
• Enable the SIP trunk.
• Configure the SIP ID, registrar Server Address, Registrar Server Port, Authentication ID,
Authentication Password as provided by your ITSP.
• If your ITSP uses Outbound Proxy, Enable the Outbound Proxy for the SIP trunk and also
program the Outbound Proxy Server Address and Port as provided by your ITSP.
The maximum number of SIP trunks supported by PRASAR UCS is 99.
By default, one NX DBM VOCODER64 module is factory fitted, hence you can configure all SIP
trunks on the same module.
To Next Page
Loading...