Matrix PRASAR UCS Quick Start 4
Installing the System
Before you Start
Before you begin the installation of the SPARK200, make sure that the required wiring has been
done and you have the following items ready:
• PRASAR UCS SME/ ENT Application License.
• Appropriate cables to set up and test the WAN interface of the system and the LAN
connection.
• A standalone PC or a PC connected in LAN.
• A SIP Account to test VoIP connectivity.
• One or more IP Phones for testing.
• Make sure you have separate electrical earth for the safety of the product and the people
handling it.
• Always wear a properly earthed (grounded) electrostatic discharge preventive belt or wrist strap
while handling the System.
• Do not install the system near any source of water, corrosive fumes and electromagnetic noise
such as radio equipment, heavy transformers, faulty electric chokes of tube-lights, device
having a faulty coil, to avoid electromagnetic effect.
For detailed instructions, refer to the System Manual.
• Unpack the system.
• Make sure that your package contains all the below items. If any item is missing or damaged,
please contact the source from where you have purchased the system.
•SPARK200
•2 RJ45 Cables
• 1 Vocoder Module factory fitted
• 1 8GB USB 2.0 Pen-Drive (Flash Drive) factory fitted
To Next Page
Loading...