10 Matrix PRASAR UCS Quick Start
Connecting SIP Extensions
You can register any SIP-enabled device, like an IP Phone, a Soft phone, Analog Telephone
Adapter (ATA) as the SIP Extension of the PRASAR UCS.
The maximum number of SIP Extensions supported by PRASAR UCS ENT Application are 2100
1
.
To register SIP Extensions the VOCODER Module is a must. You can register upto 2100 SIP
devices with one module.
If required, you can install additional modules. For detailed instructions, refer “Installing the
VOCODER Module”.
• By default, PRASAR UCS ENT Application License
2
, supports configuration and registration of
200 SIP Extensions only. If you want to use additional SIP Extensions, you need to purchase the
IP Subscriber license. The following licenses are available — PRASAR IPSUB5, PRASAR
IPSUB10, PRASAR IPSUB50, PRASAR IPSUB100 and PRASAR IPSUB500.
• For more information on Licensing, refer to the topic License Management in the System
Manual.
You may also connect/register the following as SIP Extensions of PRASAR UCS:
• SPARSH VP248, the Extended IP Phone
• SPARSH VP310, the Executive IP Phone
• SPARSH VP330, the Touch Screen Extended IP Phone
• SPARSH VP510, the Premium IP Phone
• Extended SPARSH VP710, the Smart Video IP Deskphone
• Matrix VARTA WIN200, Unified Communication Client for Windows
• Matrix Mobile UC Clients, as given below:
• Matrix VARTA AMP100, the Mobile UC Client for iPhones.
• Matrix VARTA ADR100, the Mobile UC Client for Android Smartphones/Tablets.
• Third Party (Standard) SIP Phones
The SIP Extensions may be registered over WAN or LAN according to your preference and your IP
network installation scenario. Extended SIP Clients can be registered with PRASAR UCS using
IPv4 Addresses only.
You can register the same SIP Extension from three different locations.
1. PRASAR UCS SME Application supports 250 SIP Extensions.
2. By default, PRASAR UCS SME Application License supports configuration and registration of 100 SIP
Extensions only
To Next Page
Loading...