Matrix PRASAR UCS - System Power ON; Powering On PRASAR UCS; LEDs During System ON

Matrix PRASAR UCS Quick Start 21
Switching ON the system
Power ON PRASAR UCS
• Check the mains voltage at the power plug from where the power supply is to be fed to the
system. It should be as per the specifications mentioned in the System Manual.
• Connect the Power Adapter into the power jack, and plug it into a power outlet.
• Switch ON the power supply and observe the reset cycle.
LED Indication
At Power ON, Power (PWD) LED will turn ON (Continuous Green) and the Status (STS) LED
indications will be as follows:
Event Color and Cadence
After power On, During Uboot process Orange Continuous ON.
During Kernal init Process Green Continuous ON
In normal condition Blinking - Green, 1 sec ON – 1 sec OFF
When system is in the recovery mode
Blinking - Red - 100ms ON - 100ms OFF -
100ms ON - 100ms OFF - 100ms ON - 5000ms
OFF continuously
“Octasic” module has stopped working
Blinking Orange, 500 msec ON - 500 msec OFF
– 500 msec ON – 500 msec OFF – 500 msec
ON – 5000 msec OFF continuously
System is in the Thermal Sleep Mode.
Blinking Red, 2 sec ON - 500 msec OFF – 2 sec
ON – 500 msec OFF – 2 sec ON – 5000 msec
OFF continuously