Matrix PRASAR UCS - Installing the VOCODER Module

Matrix PRASAR UCS Quick Start 5
•A Power Adapter
• A Power Cord (country specific)
• Two Side Clamps
Installing the VOCODER Module
SPARK200 supports four NX DBM VOCODER64 modules. By default, one module is factory fitted
in the product. If required, you must purchase the other modules separately. The system supports
a maximum of 248 VOCODER channels. Each NX DBM VOCODER64 module supports a
maximum of 64 VOCODER channels. By default, 8 VOCODER channels are pre-activated when
you purchase PRASAR UCS SME/ENT Application License. If you require more channels, you can
purchase the licenses accordingly. Matrix provides two VOCODER licenses — PRASAR
VOCODER CHNL4 and PRASAR VOCODER CHNL16.
To install the module,
• Unpack the NX DBM VOCODER64 module.
• Make sure you are wearing an electrostatic discharge preventive wrist strap or belt and power
supply is switched off. Unplug the adapter, if you have connected it.
• Unscrew the unit. There are screws on the sides as well as the back panel.