8 Matrix PRASAR UCS Quick Start
• Press the Module with a finger and match the mounting holes perfectly with the stud holes.
Make sure you do not touch the PCB area of the module except the yellow line provided for
grounding at the front end of the module.
• Do not apply excessive pressure.
• Secure the module with the screws on the studs.
• Follow the same steps to install another module.
Removing the VOCODER Module
• Locate the VOCODER Module you want to remove from the board.
• Remove the screws from the module and keep them aside.
• Firmly hold the module and ease it out of the PCI connector carefully.
• Replace the screws on the studs.
VMS Interface and the Internal USB Ports
The System supports a maximum of 64 VMS channels. By default, both PRASAR UCS SME/
PRASAR UCS ENT offers 4 pre-activated VMS channels. To activate additional VMS channels, you
must purchase — PRASAR VMS CHNL4 or PRASAR VMS CHNL16. For more information see the
topic License Management in the PRASAR UCS System Manual.
To Next Page
Loading...