Legal & Safety Stuff
These instructions provide important information concerning
the proper operation of the product. Only use this product
aer carefully reading the operating instructions included
with the product and all warnings and labels on the product
packaging, including the manual and any separately included
sheets. Only use this product with the included accessories
and the included power adapter. Do not use this product or
any Matter and Form Inc. online services for purposes that
could infringe on the intellectual property of a third party.
Matter and Form Inc. assumes no responsibility whatsoever
with regard to the infringement of intellectual property
through use of the Matter and Form 3D Scanner or Matter and
Form Inc. online services. The Matter and Form 3D Scanner
comes with a limited warranty, in addition to any warranties
mandated by local laws. Details of the warranty can be found
at https://matterandform.net/legal
Matter and Form Inc.
243 College St., Suite 401
Toronto, Ontario
Canada, M5T 1R5
Please note the following important safety instructions:
● Do not operate this product if it is damaged, or if the
power cable or USB cable are damaged or if any of its
internal features are exposed.
● Only use the cables and power adapters provided
with the scanner. If you require a replacement, please
contact Matter and Form Inc. at
support@matterandform.net
● Do not operate the product when wet. If it should
become wet, do not turn it on. Disconnect it from its
power source and do not operate it until completely
dry.
● Do not touch the camera lens, laser lenses or laser
housing.
● If your product requires maintenance or repair,
contact Matter and Form Inc. at
support@matterandform.net . Do not attempt to open
or repair the product on your own, as it may be
hazardous and will void your warranty.
To Next Page
Loading...