FCC Class B Notice
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and
receiver.
● Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
● Consult the dealer or an experienced radio/television
technician for help.
You may also find helpful the following booklet, prepared by
the FCC: “How to Identify and Resolve Radio-TV Interference
Problems.” This booklet is available from the U.S.
Government Printing Office, Washington D.C. 20402.
Modifications: Any modifications made to this device that are
not approved by Matter and Form Inc. may void the authority
granted to the user by the FCC to operate this equipment.
Laser Stuff
“Complies with FDA performance standards for laser
products except for deviations to Laser Notice NO-50, dated
June 24
2007. Class 1 laser product classified under IEC60825-1:2007.”
To Next Page
Loading...