9
i-32V5
5.
Select the operang mode and manually reset any alarms.
Each me you press the key you have the following sequence:
OFF -> COOL -> HEAT -> OFF
If DHW is enabled, the sequence is the following:
OFF -> COOL -> COOL+SAN -> HEAT -> HEAT+SAN -> OFF
While seng the parameters, this key has the funcon of sending BACK by one level.
Grants access to the parameter seng menu and allows you to set the summer, winter and sanitary setpoint.
UP key. In the parameter seng mode, it allows you to move to a higher menu or to increase the parameter value when in “edit”
mode.
DOWN key. In the parameter seng mode, it allows you to move to a lower menu or to decrease the parameter value when in
“edit” mode.
MENU
MENU LABEL PASSWORD LEVEL OTHER CONDITIONS
Setpoint Set User Not accessible if connected to Hi-T2
Probes tP Installer ---
Alarms Err User Only if acve alarms
Digital input Id Installer ---
Parameters Par Installer ---
Password PSS User ---
Hours of operaons oHr Installer ---
USB USb Installer Only with pen drive with relevant update les
Versione Firmware Fir Installer Version, Revision and Sub
Alarm log Hist Installer Only if the log contains data
SETPOINT MENU
SETPOINT DESCRIPTION UNIT DEFAULT RANGE
Coo First Summer setpoint °C 7.0 5 ÷ Co2
Hea First Winter setpoint °C 45.0 25 ÷ 60
*San Sanitary setpoint °C 48.0 25 ÷ 60
Coo2 Second Summer setpoint °C 18.0 Coo ÷ 25
Hea2 Second Winter setpoint °C 35.0 25 ÷ Hea
San2 Second Sanitary setpoint °C 35.0 25 ÷ Hea
**rCoo Mixing valve Summer setpoint °C 15.0 0.0 ÷ 80
To Next Page
Loading...
