Maxi-Cosi Mico Plus - Fitting Carrier to Aircraft Seat

46
I
Mico Plus
I
Maxi-Cosi
Aircraft installation
Fitting the carrier to the aircraft seat
As the top tether is not required in this installation process, please refer to page 38
for instructions on how to store your top tether strap.
a
• Remove top tether extension from car and clip each
end onto the ISOGO lower connector storage points
as shown in (figure a).
• Tighten top tether strap (as detailed on page 36) so
that the connecting strap is firm to the base.
• Tighten ISOGO lower connectors (as detailed on page
43) until the belt path is exhausted.
• Position the carrier rearward facing. Ensure the
carrier is aligned centrally with the seat position.
Folding the arm rests upwards could facilitate the
installation of your carrier.
• Pull back cover on the side (figure b). to reveal
AIRCRAFT SEATBELT PATH label marked in
green.
AIRCRAFT
REARWARD
FACING BELT
PATH
b
AIRCRAFT
SEATBELT
PATH
Never use this path in a car
Note: Never use this path in a car.