Do not operate the machine for more than 5 minutes while dispensing or washing. Over-long
operation may cause the rotary pressure pump motor to stop. If it is stopped, wait for about
15÷20 minutes to reset the motor overload temperature before reactivating the machine.
5 MACHINE OPERATION
5.1 Controls
The control panel functions are illustrated below:
1. Digital display Displays the temperature of the liquid cream, contained in the
extractable tub, inside the refrigeration tank.
2. “0/1 ON/OFF” button For switching the machine on and off. When the machine comes
on, the following values are shown on the digital display (2) in this sequence: the factory set preservation temperature
for the liquid cream (+3°C) and then the temperature of the internal surface of the refrigeration tank.
3. “DISPENSE” button For dispensing whipped cream continuously in adjustable doses
and in manual mode. Dispensing will last until the button is released.
To Next Page
Loading...
