48
options / unique Features
magnetic dynamic brake system
Gear Reducer
This unique built-in feature controls the gate’s open and close stopping positions. When a gate is installed on a slight incline or
decline, gate coasting can be a concern. When the motor stops, the momentum of a heavy gate can continue coasting beyond
the gate’s stopping position. This can be a problem, especially when closing bi-parting gates meet. The MAX 1500 / 2200 WILL
NOT ALLOW gate coasting beyond it’s learned stopping position, even when the gate is installed on a slight incline or decline.
This feature does NOT allow the gate to be manually pushed open by
multiple people. It takes several thousand pounds of force to physically
move the gears on the gear reducer. Even if several people try and
push the gate open, the gear reducer ratio will prevent gate movement.
If the gate does move, the GATE TAMPER feature will activate and the
proper authorities can be automatically notified if desired.
Other gate operators can coast when motor
stops, causing gates to hit each other.
MAX 1500 / 2200 WILL NOT ALLOW gate coasting.
Gates stop at the same position every time.
“Like NO other Gate Operator in the World”
Other Gate Operators
MAX 1500 / MAX 2200
The gate WILL NOT
move using human force.
To Next Page
Loading...
