Maximum Controls MAX 2200 PRO - Learn Gate Positions; Adjust ERD Reverse Sensor

learn gate positions
7
1. Push OPEN button to cycle gate to open position.
Operator cycles slowly while learning position.
2. Then push CLOSE button to cycle gate to closed position.
Operator cycles slowly while learning position.
Gate positions have now been learned.
Gate
Shut-Off
Switch
After the virtual limits have been programmed and at least ONE entrapment sensor has been installed in EACH direction,
put the gate in the CLOSED position:
IMPORTANT:
GATE SHUT-OFF Switch MUST be OFF.
(see page 14 for more information about switch)
The ERD Sensor - Electronic Reversing Device (Type A) MUST be adjusted for the OPEN and CLOSE gate cycles.
When the gate encounters an obstruction during the CLOSE cycle, it will reverse to the open position and PAUSE the gate.
An input command (press remote button or exit loop) is needed BEFORE the gate will reset and close again.
When the gate encounters an obstruction during the OPEN cycle, it will reverse approximately 6 inches and PAUSE the gate.
An input command (press remote button or exit loop) is needed BEFORE the gate will reset and open again.
For the ERD Sensitivity to function correctly:
• Gate positions must be learned BEFORE adjusting the ERD Sensitivity. See above.
A. Turn knob until blue LED lights up.
Maximum sensitivity reached,
Position 1 - Too sensitive for most gates.
Position 13:
• Typical gate setting.
B. Turn knob counter-clockwise to
reduce gate sensitivity while testing ERD
until desired results is attained.
(LED remains OFF for all but position 1)
IMPORTANT: When satisfied
with ERD adjustment, cycle
the gate 3 or 4 times to make
sure that the ERD sensor does
not falsely trigger during
normal gate operation.
Re-adjust if this happens.
CAUTION: Position 16 results in gate exerting
MAXIMUM force before reversing direction.
Adjusting ERD in EACH direction:
Typical Settings:
Position 16:
• Heavy gate setting.
• Long gate setting.
• Cantilever gate setting.
• Uphill gate setting.
• High wind area gate setting.
Adjust ERD Reverse sensor
8
MOTION CONTROL
OPEN
STOP CLOSE
MOTION CONTROL
OPEN STOP
CLOSE
After gate positions have
been learned, the gate will
cycle at the speed set on
“GATE SPEED” settings.
16 sensitivity setting positions in EACH direction.
NO mechanical hard stops for knobs.
ERD SENSITIVITY
3
1
14 12
9
7
MAX
SENSE
ERD SENSITIVITY
MIN
16
3
1
14 12
9
7
OPENING CLOSING
ERD
MOTOR
OVER
LOAD
ERD
MOTOR
OVER
LOAD
MAX
SENSE
MAX
SENSE
ERD SENSITIVITY
MIN
3
1
14
16
MIN
16
12
9
7
3
1
14 12
9
7
MAX
SENSE
ERD SENSITIVITY
MIN
16
3
1
14 12
9
7
MAX
SENSE
ERD SENSITIVITY
MIN
16
3
1
14 12
9
7
If alarm sounds while adjusting ERD,
press STOP BUTTON to shut-off alarm.
MOTION CONTROL
OPEN
STOP
CLOSE
Typically set to MAX, LEDs ON.
CLOSINGOPENING
GATE SPEED
MIN MIN
MIN
MIN
MIN
MI
M
M
MIN
MIN
MIN
MI
M
M
MAX MAX
1
MAX
SENSE
16
MIN
CAUTION: Keep pedestrians and vehicles clear of the gate while adjusting sensors.
10
UL 325 2018 Standard - MAX 1500 PRO/2200 PRO/F18 PRO Matrix III Install Version 7d