Maximum Controls MAX 2200 PRO - Step-By-Step Installation Guide; Operator Mounting Positions

CLOSING Photocell Beam
OPENING Photocell Beam
Reflector
CLOSING
Sensing
Edge with
Wireless
Module
Operator Placement (standard)
1A
V-Rail
Physical Stop
Concrete Pad
Operator
Position on
Concrete Pad
Operator in Front Position (Standard)
Operator in Front Position (Standard)
Outside Property
Inside Property
24”
24”
Wireless
Module
Gate in Closed Position
4”4”
2” Gate Frame
10.5”
10.5”
6.2”
6.75”
7.5”7.5”
6.75”
Cover
1.5”
4”5”
6.5”
The gate must be properly installed and work freely in both directions prior to installation of the gate operator.
• REQUIRED - AC input power wire.
• REQUIRED - Entrapment protection OPENING and CLOSING photocell
and/or sensing edges.
• In-ground loop wires.
Conduit Guidelines and Suggestions
8.625”
12.75”
Conduit
Area
Input Power
Conduit Run
Concrete Pad
Check local building
codes in your area for
depth of concrete
before installation.
Guide rollers MUST be Installed to keep gate upright.
6” above ground to avoid flooding.
Concrete Depth Note: The heavier the gate, the deeper the concrete pad should be. At least two feet recommended for heavier gate.
Secure gate operator to
concrete pad with four
(4) 1/2” x 3” (min)
sleeve anchors.
1/2
Wireless
Module
CLOSING
Sensing
Edge with
Wireless
Module
Guide Rollers
Safety sensors (Photocell or contact EDGE) must be
installed in BOTH opening and closing direction of gate
movement where entrapment or pinch point exist. TWO
safety sensor min. (N.C. or 10K type) MUST be installed or
operator will NOT function. All sensors must be UL325,
2018 compliant. See pages 7-8.
UL 325 2018 Standard
IMPORTANT: Physical stops MUST
be installed on BOTH ends of rail to
keep gate from traveling off of rail.
IMPORTANT:
Physical Stop
MUST be installed
See next page for chain information.
Choose either Front Mounting Position (Standard) or Rear Mounting Position (Alternate).
1A 1B
OPENING Sensing Edge with Wireless Module
OPENING Sensing Edge with Wireless Module
Operator MUST be level.
step-by-step installation
1
UL 325 2018 Standard - MAX 1500 PRO/2200 PRO/F18 PRO Matrix III Install Version 7d