11. MULTIMEDIA (only with connected and operational external
HDD)
This menu is primarily regarding a
connected hard disk.
• Record List
• HDD Settings
• HDD Properties
11. 1 Record List
A set timer causes the receiver to wake up from standby mode at the
specified time and change the channel to the specified one.
If an external HDD is connected to the USB port and is operational, recordings
can be made directly on the HDD. The following functions (Timer-Status) can
be chosen from:
- Off: No Timer setting
- On: The Receiver at the desired time switches on the chosen channel.
- Pre-Recording: If a HDD is connected and operational, at the set time the
pre-programmed broadcast will be recorded on the HDD.
Please note: Timer settings that have been programmed in the EPG (see
EPG-Timer point 6.4) are automatically marked in the Timer list as
“Recording“ and can be edited or deleted here.
11. 2 PVR Settings
You can select the default duration for
direct recordings. For direct recordings a
window then appears after pressing the
RECORD key which displays this pre-
defined setting.
You can also set the padding time
(beginning and end time before and after
a programmed recording) – choose
between: None, 5, 10, 15, 20, 25 and 30
minutes.
To Next Page
Loading...
Need help?
General
