Maintenance
Care & Maintenance
maxon BIKEDRIVE | User Manual | rel6003 17
2.1.4.2 Reassembly
IMPORTANT!
• During reassembly, parts can easily be damaged. Exercise caution.
• To attach the brake disc, use only the maxon «Brake Screw Kit TX25»
(519904), the originally used, or as to below specified screws.
• The screws must not axially touch the bottom of the tap. Wrong or too long
screws lead to permanent damage of the motor.
Use «Brake
Screw Kit
TX25»
or
check
dimensions
RECOMMENDATION:
Use maxon’s «Brake Screw Kit
TX25» (upper illustration).
If you decide not to use the
maxon screw kit:
Make sure that fastening screws
and washers correspond with
the indicated dimensions
(lower illustration)!
Mount
brake disc
1) Check brake disc and hub for
cleanness, clean if necessary.
2) Observe specified brake
disc’s sense of rotation.
3) Slide brake disc (F) on hub,
align radially.
4) Mount spacer plate (G).
5) Mount screws (H) from
«Brake Screw Kit TX25» (for
others, apply medium
strength threadlocker first),
lightly tighten by hand.
6) Turn brake disc against direc-
tion of travel until it strikes
against screws.
7) Tighten screws crosswise
(torque 7 Nm).
To Next Page
Loading...