The time interval to send heart beat packet. Valid only
when you choose UDP(DTU) or TCP(DTU) protocol .
Enable or disable GPS function
You can send GPS data to the Network or the serial
interface
The GPS Service Center IP address or domain name
GPS Center
Listening Port:
GPS Service Center listening port
GPS Information
Update Interval
The time interval between two GPS information
updates. Unit is seconds.
A device ID that can be sent with the GPS data
Here you can setup the serial port baud rate, databit,
Parity, Stopbit and Flow control settings.
Enable GPS: Enable or disable GPS function
GPS Output Interface: This item selects the GPS output interface
including network and serial port
GPS Center Address: The GPS center’s IP Address or domain name
GPS Center Listening Port: The GPS center’s listening port.
GPS Information Update Interval (Seconds): The time interval between
two GPS information updates. Unit is seconds.
When GPS output interface is serial port, we should set the following serial
port settings:
To Next Page
Loading...
Need help?
General
