11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
18
STEP 6 - INSTALL CONTROL SWITCH - Continued
4. Open the Pump Box Cover.
Connect the RED, BLACK,
GREEN, and WHITE wires
from the Control Switch cable
to Pump Wiring as shown in
FIG. 18-1.
CONNECTING CONTROL SWITCH
CABLE TO PUMP WIRING
FIG. 18-1
WHITE WIRE GREEN WIRE
BLACK WIRE
RED WIRE
CRIMP
TERMINALS
“A” VALVE
“A” VALVE
WIRE
“E” VALVE
“E” VALVE
WIRE
NOTE: MAXON recommends using dielectric
grease on all electrical connections.
NOTE: An extra crimp-on connector is supplied
with the RED wire and BLACK wire on
the Control Switch cable. Crimp each
of the extra connectors to the correct
wires shown in the illustration.
To Next Page
Loading...
