Maxon GPT-25 - Step 11 - Install & Adjust Saddles

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
25
STOWED LIFTGATE - SIDE VIEW
(RH SIDE SHOWN)
FIG. 25-1A
STEP 11 - INSTALL & ADJUST SADDLES
GAP BETWEEN PLATFORM & ROLLER
FIG. 25-1B
PLATFORM
1/8”
GAP
LIFTING FRAME
BRACKET
ROLLER
BOLTS &
LOCK NUTS
SADDLE
MOUNTING
PLATE
HINGE
1. Stow the Platform as shown in
FIG. 25-1A. Use floor jack posi-
tioned at center of Platform (near
hinge) to raise Platform 1/8” above
Roller (FIG. 25-1B). Install Saddle,
Bolts and Lock Nuts on RH side
Mounting Plate (FIG. 25-1A).
Repeat for Saddle on LH side.
Butt each Saddle against Platform,
and tighten lock nuts.
2. Install Saddle, Bolts and Lock Nuts
on RH side Mounting Plate (FIG.
25-1A). Repeat for Saddle on LH
side. Butt each Saddle against
Platform, and tighten lock nuts.
Make sure Mounting Plates are cooled before installing Saddles. Hot surface could
result in personal injury and damaged Saddles.
CAUTION
!