Maxon GPT-25 - Step 2 - Weld Extension Plate to Vehicle

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
8
STEP 2 - WELD EXTENSION PLATE TO VEHICLE
1. Center the Extension Plate on vehicle body. Before welding Extension Plate to vehicle
body, make sure top surface of Extension Plate is flush with floor of vehicle body. Weld the
Extension Plate to vehicle body sill as shown in FIG. 8-1 and FIG. 8-2.
EXTENSION PLATE WELDS - VIEWED FROM UNDERNEATH
FIG. 8-2
SILL
(PART OF
VEHICLE BODY)
2 PLACES, MAKE 1”
GAP WHERE SHOWN
1/4”
2” LG, 12 PLACES
EQUAL SPACING
(TYP.)
1/4”
1/4”
5 PLACES, MAKE 1”
GAP WHERE SHOWN
1” GAP
1” GAP
4” LG. LOCATED ABOVE EACH OF
3 RECTANGULAR TUBES (TUBES
SHOWN SHADED IN FIG. 3)
2” LG. CENTERED
BETWEEN
4” WELDS SHOWN
4” LG.
EXTENSION PLATE WELDS - VIEWED FROM ABOVE
FIG. 8-1
SILL
(PART OF VEHICLE BODY)
1/4”
1/4”
1/4”
1/4”
4” LG.
1” GAP