11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
14
Clip Fused Power Cable to vehicle chassis, with fuse nearest the vehicle battery, as shown in
FIG. 14-1. Keep enough cable near the battery to reach the positive terminal without putting
tension on cable (after connection). Run bare wire end of cable to Liftgate.
STEP 4 - RUN POWER CABLE
FIG. 14-1
FUSE
SHORTEST
CABLE END
TERMINAL LUG
(VEHICLE BATTERY
END)
VEHICLE FRAME
(TRUCK FRAME SHOWN)
18” - 24”
SPACING
BARE WIRE END
(TO PUMP BOX)
FRONT OF VEHICLE
REAR OF VEHICLE
CABLE
CLIPS
Never route an energized wire. Make sure the vehicle battery is disconnected.
Always route electrical wires clear of moving parts, brake lines, sharp edges and
exhaust systems. Avoid making sharp bends in wiring. Attach securely. If drilling is
necessary, first check behind the drilling surface so you do not damage any fuel
lines, vent lines, brake lines or wires.
CAUTION
!
To Next Page
Loading...
