Maxon GPT-25 - Page 37

11921 Slauson Ave. Santa Fe Springs, CA. 90670 (800) 227-4116 FAX (888) 771-7713
37
RECOMMENDED LIFTGATE POWER CONFIGURATION - Continued
OPTIONS
12 VOLT BATTERY CONNECTIONS
FIG. 37-2
(-) BATTERY
CABLES
150 AMP CIRCUIT
BREAKER
(+)
BATTERY
CABLES
POWER CABLE
TO PUMP BOX
3. Recommended Battery Box
setup for 12 volt batteries is
shown in FIG. 37-2.
200 AMP FUSED POWER CABLE
(ONLY IF REQUIRED - SEE NOTE)
150 AMP CIRCUIT BREAKER
(NEAR TRUCK OR TRACTOR
BATTERY AND/OR
NOSE OF TRAILER)
NOTE: If more than 10’ of cabling is required to connect Battery Box batteries to
Liftgate Power Unit, and/or if cable is run through/along vehicle body
crossmembers, use 200 Amp Fused Power Cable from Liftgate Parts Box.
Always connect fused end of Cable to Battery.
CHARGE LINE TO
TRUCK OR TRACTOR
BATTERY
(-) BATTERY
CABLE
6 VOLT BATTERY CONNECTIONS
FIG. 37-1
150 AMP CIRCUIT
BREAKER
(+)
BATTERY
CABLES
POWER CABLE
TO PUMP BOX
200 AMP FUSED POWER CABLE
(ONLY IF REQUIRED - SEE NOTE)
2. Recommended Battery Box
setup for 6 volt batteries is
shown in FIG. 37-1.
CHARGE LINE TO
TRUCK OR TRACTOR
BATTERY
NOTE: If more than 10’ of cabling is required to connect Battery Box batteries to
Liftgate Power Unit, and/or if cable is run through/along vehicle body
crossmembers, use 200 Amp Fused Power Cable from Liftgate Parts Box.
Always connect fused end of Cable to Battery.
150 AMP CIRCUIT BREAKER
(NEAR TRUCK OR TRACTOR
BATTERY AND/OR
NOSE OF TRAILER)