Extended AT Commands Manual Page 63 of 70 2009-06-25
Command
Value
per
Description
Packet
Data
+IFC IS-131
TE2-MT2 Local Flow Control. This extended-format compound
parameter is used to control the operation of local flow control
between the TE2 and MT2
[1]
.
<c_by_t> Description
0 None
1 Xon/Xoff local
DC1/DC3 on circuit 103; do not pass
DC1/DC3 characters to the remote DCE.
2 Circuit 133 (Ready for Receiving) (Default)
3 Xon/Xoff global
DC1/DC3 on circuit 103 with DC1/DC3
characters being passed through to the
remote DCE in addition to being acted upon
for local flow control
<t_by_c> Description
0 None
1 Xon/Xoff local
DC1/DC3 on circuit 104
2 Circuit 106
Clear to Send/Ready fo
Sending) (Default)
<c_by_t>: specifies the method to be used by the DTE to control
the flow of received data from the DCE;
<t_by_c>: specifies the method to be used by the DCE to control
the flow of transmitted data from the DTE.
AT+IFC=<[[c_by_t]DCE_DTE]>,<[[t_by_c]DTE_DCE]>
+IFC? Shows current settings
+IFC=? Shows supported range
+IFC=<c_by_t,t_by_c> sets value
R
To Next Page
Loading...