1. Tuning the unit On / Off
Press any Button to turn the unit on, the
display will show a message Welcome to
Car Audio to indicate it is ready for use.
Press the PWR button once to turn the
unit off. The display will show a message
“GOODBYE”.
2. Mode Selection
Press the MOD Button to cycle the Play
Mode amoung AUX, RADIO and CD PLAY.
Note: USB mode will only show on the
display when a USB flash memory is
inserted into the USB port.
3. Loudness Control
Press the SEL button until “LOUD OFF”
is shown on the display indicates that
the loudness function is OFF. Turn the
volume knob to select between ON or
OFF.
4. Mute Control
Press POWER/MUTE Button on the panel
or MUTE Button on the RC to swith off
the sound. Press it again or rotate VOL
knob or press VOL+/- buttons on the RC
to resume the sound.
5. Volume
Use the VOL knob to adjust the volume
level. The larger the number, the higher
the volume level.
6. Bass
Press the SEL Button repeatedly until the
display shows “BAS”. Use the VOL knob
to adjust. When EQ is ON, bass control is
not available.
7. Treble
Press SEL Button repeatedly until the
display shows “TRE”. Use the VOL knob
to adjust. When EQ is ON, treble control
is not available.
8. Balance
Press SEL Button repeatedly until the
display shows “BAL”, then use the VOL
knob to adjust the balance between the
left & right speakers.
9. Fader
Press SEL Button repeatedly until the
display shows “FAD”, then use the VOL
knob to adjust the balance between the
front & rear speakers.
10. Clock
The time clock can be set anytime
when the power is on. Press the PTY/
CLK Button on the faceplate or remote
control once (press and hold for more
than 2 seconds during radio mode), the
time will show on the display.
Then press and hold the button until the
hour blinks on the display. Rotate the
VOL knob to set hours, then press the
VOL knob for the minutes to blink and
rotate the VOL knob to set.
Press the CLK button again or leave the
unit idle for new setting to effect. Press
the CLK button anytime to view the time
clock display.
11. Preset Beep Sound Off
Press the SEL button repeatedly until
“BEEP ON” is displayed. Turn the VOL
knob to select “BEEP OFF” or “BEEP ON”,
then leave the unit idle for setting to
take effect.
12. Preset Equalizer Function
Press the SEL Button repeatedly until
“EQ” indication is displayed then rotate
the Volume knob to choose between
the EQ sound effects. The Sequence of
equalizer setting will be as follows:
Basic Operation
To Next Page
Loading...