Radio Operation
1. Choose Radio Band
Press the MOD Button to access the radio
function.
The unit comes with five bands- three FM
Bands (FM1, FM2, and FM3) and two AM
Bands (AM1, and AM2) selects. Each of
the five bands can store up to six preset
stations, for a total of 30 preset memory
stations.
2. Radio Tune / Seek Function
In Radio Mode, press Seek +/- Button to
manually adjust the radio frequency.
3. Tuning
• Manual tuning: Press and hold |<< or >>|
button on the panel until the screen shows
MANUAL. Press these buttons repeatedly
to manually adjust the radio frequency. Or
press repeatedly shortly |<< or >>| button
on the RC to manually adjust the radio
frequency.
• Auto tuning: Press shortly |<< or >>|
button on the panel or press and hold
|<< or >>| button on the RC the radio will
seek to the next up or down strong and
clear frequency station automatically.
Repeat this action to seek for other desired
stations. To stop automatic search, press
one of these buttons.
4. Mono / Stereo Reception Control
In FM radio mode, Press the SEL Button
repeatedly until the display shows
“STEREO”, then use the VOL knob to
select between “STEREO” or “MONO”.
5. Save Your Preset Stations
There are six numbered preset buttons
which can store and recall stations for each
band. While listening to a radio station
you would like to save as a pre-set, press
and hold one of the buttons numbered
1-6 until you hear a beep. The button you
pressed is now the pre-set button for that
station.
6. Automatic Store / Preset Scan
There are six numbered preset stations
which can store and recall stations for each
band. While listening to a radio station you
would like to save as a preset, press and
hold one of the buttons numbered 1-6
until the number of the radio change to
the number you selected. The button you
pressed is now the pre-set button for that
station.
A. Automatic Scan & Store
While listening to the FM Radio, press and
hold the F/PS Button. The receiver will
automatically scan and save stations of the
3 FM Bands.
While listening to the MW Radio, press
and hold the F/PS Button. The receiver will
automatically scan and save stations of the
2 MW Bands.
B. Scan & Preview Saved Stations
Press the F/PS button once and the receiver
will scan the radio stations in the current
band.
To Next Page
Loading...