Installing the Hard Drive 5
2
Installing the Hard Drive
This chapter describes how to physically install the hard drive in your
computer. The installation steps are as follows:
• Remove the system cover.
• Set the jumper.
• Mount the hard drive in your computer.
• Attach the cables.
• Configure the BIOS (Windows-based systems only).
Removing the System Cover
1.
Turn your computer off.
2.
Unplug your system from the electrical outlet.
3.
Remove the cover from your system case.
Refer to your system
user manual for instructions on removing the cover, or obtain the
services of a qualified installation technician.
4.
Attach a grounding strap or touch a metal portion of your
computer case.
This will ground you to minimize the risk of
exposing the hard drive to electrostatic discharge.
Figure 3
Removing the System Cover
To Next Page
Loading...
Need help?
General
