Maxx Ice MIM50V - Operation; Final Check List Prior To Operation; Operating Method

8
OPERATION
Final Check List Prior To Operaon
1. Have all packing materials and tape been removed from the interior and exterior of the ice maker?
2. Did you clean the ice storage bin?
3. Have the installaon instrucons been followed, including connecng the machine to water, drain and
electricity?
4. Has the machine been leveled?
5. Is the ice maker in a site where the ambient temperature is between 50°F (10°C) and 100°F (38°C) and the
water temperature between 41°F (5°C) and 90°F (32°C) all year-round?
6. Has the water supply pressure been checked to ensure a minimum of 15 psig with a stac pressure not to exceed
80 psig?
7. Is there a clearance of at least 4" (102 mm) at the rear, and 1" (25 mm) at top and sides for proper air
circulaon?
8. Has the power supply voltage been checked or tested against the nameplate rang? And has proper grounding
been installed in the ice maker?
9. Is the ice maker plugged in?
10. Have you turned on the main water supply and tap?
11. Have you checked for leaks at all water supply connecons?
Operang Method
1. Turn on the water tap, let the water trough ll, then press the ON/OFF buon on the front panel. The ice
maker will start working automacally.
Ice Making Stage Ice Harvest Stage Bin Full Stage
2. Aer 3 minutes, the machine will automacally go to the ice-making stage, and the sound of water owing
will be heard.
3. When the batch of ice has been fully formed, ice will automacally be harvested to the ice storage bin.
4. When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the bin-full probe
open. The machine stops making ice automacally.
5. The unit will start making ice again aer the ice cubes are removed. Then the bin-full probe swings back to
operang posion.
NOTE:
• Although the unit has been tested and cleaned at the factory, due to long-term transit
and storage, the rst batch of cubes must be discarded.
• Never turn the water supply tap o when the ice maker is working.
• Never touch evaporator when unit is running!
• Except to take ice from the unit, keep the door closed to reduce melng and insure
proper ice formaon.