Maxx Ice MIM50V - Major Functions; Trouble Shooting

13
MAJOR FUNCTIONS
1. The operang procedure is completely automac.
2. When the ice storage bin is full of ice cubes, the machine stops making ice automacally. It starts making ice
again aer ice cubes are removed.
3. The dierent colors of the LED display indicate various work modes.
4. A sensive probe and accurate mer enhance the performance of the ice maker.
5. A compressor protecon system is built in.
TROUBLE SHOOTING
Problem Possible Cause Probable Correcon
The machine
doesn’t operate.
The ice maker is unplugged. Plug the ice maker in.
The fuse is blown.
Replace fuse. If it happens again, call for service to
check for a short circuit in the unit.
The ice maker power buon is set at OFF. Switch the ice maker power buon to ON.
The ice storage bin is full of ice.
Remove some ice cubes. Be sure the ice-full probe
is free of ice.
The water doesn't
feed in aer the
machine starts.
The water supply tap is turned o. Turn on the water supply tap.
The water supply pipe is not properly connected. Reconnect the water supply pipe.
Machine makes ice,
but bin does not ll
up with ice.
The condenser may be dirty. Clean the condenser.
The air ow to the ice maker may be obstructed. Check the installaon.
The ambient temperature and water temperature
are high, or unit is near some heat source.
Check the installaon.
Water is leaking out
of the unit.
Some water falls to the oor when you open the
door to remove ice from storage bin.
Normal condensaon on the door or some water
together with ice. Take care when you take out ice.
Water supply connecon is leaking. Tighten ng. See Connecng the water line.
Drain pipe higher than drain outlet. Lower drain pipe.
Cubes are parally
formed or are white
on the boom.
Not enough water in the water trough.
Check if the water supply pressure is below 15 psig.
Check water supply or lter may be restricted.
Check for a water leak at the water trough.
Noise during
operaon
The feet are not leveled and locked.
Level and lock the feet.
See Leveling the Ice Maker.
Certain sounds are normal. See Normal Sounds.
The ice maker stops
suddenly while
making ice.
The electricity is o. Reconnect the power supply line.
The room temperature is out of the stated range.
Cut o the electricity and leave the ice maker
disconnected unl the temperature returns to
within the stated range.
The ice storage bin is full of ice.
Remove some ice cubes; make sure the ice-full
probe is free of ice.
The body of the ice
maker is electried
The ground line isn’t in the socket. Use a socket meeng the grounding requirements.
Scaling occurs
frequently inside the
machine.
The hardness level of the water is too high.
Install a water-soening device in front of the water
inlet.
Water leaks
from the ice
storage bin
The drainhole below the ice storage bin is blocked. Remove the ice storage bin and clean the drainhole.
The drain hose is kinked or improperly placed
higher than the oor of the ice storage bin.
Check the drain hose to be sure water can be
drained out unhindered.