Mayer TM 1010 - Initial Start-Up; Check Prior to First Start

19
5 Initial start-up
It is absolutely necessary to comply with the
following safety instructions for the initial start-up of
the machine. This will prevent injury to individuals,
damage to machinery and other property damage.
• The initial start-up may only be carried out by
qualified individuals, complying with the safety
instructions.
• Before the first start-up, check whether all the
tools and parts not belonging in it have been
removed from the machine.
• Before the first start-up, check the electrical
connections.
• Activate all the safety equipment and
EMERGENCY SHUT-OFF switches before the
initial start-up.
• Also read the section "General Safety
Instructions".
1. Check prior to first start
Prior to starting up the machine, the following must
be checked:
• are all safety devices available?
• was the machine damaged during transport?
• all visible bolted joints must be checked for tight
seat.
• Prior to putting the machine into operation, the
machine’s connecting cable and the cable of
the emergency cut-off switch must be checked
for damages.