Mayer TM 1010 - Shutting down the Machine; Measures Prior to and after a Longer Shutdown

31
2. Shutting down the machine
There are two ways provided to switch off the machine.
a)
In normal case by pressing switch „Stop” mounted on the
swinging cable.
In this case the machine may be restarted by pressing switch
„Start”.
b)
In emergency case by „Emergency Stop” switch.
When push button „Emergency Stop” is pressed the machine
stops immediately and remains stopped.
After „Emergency Stop” is eliminated the machine may be
started by pressing push button „Start”.
3. Measures prior to and after a longer
shutdown
a) Before a long shutdown
• Clean carefully the machine.
• Grease and oil certain parts of the machine according to
maintenance plan.
• Protect against dirt and moisture (to be covered)
• Disconnect the machine from power lines (electricity,
compressed air)
b) After a long shutdown
• Grease and oil certain parts of the machine according to
maintenance plan.
• Visually check the machine.
• Connect the machine to required energy sources.
• Start the machine as it is described in section „Initial start-
up”.