CLOCK AND OVEN CONTROL
Allindicatorwordsare displayedtoshowtheir location.The touch padsonyour rangemay
notlook likethis illustrationbutthey will operate asdescribed inthis manual.
This function pad on your !
°°°1
IT.I• I-I --I --I L I, range will be labeled either
I I • CLEANSR01L LOCK STOPTIME orOVENSTOP.
DELAY TIMED BAKE
STOP TIMERI"_ This pad will operate as
SAKE described below.
r
t
Press this pad to cancel all programming except the clock 1. Press OVEN TEMP pad.
and timer. 2. Press the • or • pad to set oven temperature.
See pages 11 to15 for additional information.
Press or press and hold these pads to enter the desired time
ortemperature or to select Hi or Lo broil. 1. Press BROIL pad. ri
2. Press • or • pad to select Hi broil or Lo broil.
See page 18 for additional information.
1. Press TIMER pad.
2. Set desired time using the • and • pads. _L_N
Press or press and hold either pad to change the time by I 1. Close and lock oven door.
minute, 5 minutes or 10 minutes.
2. Press CLEAN pad.
TIMERcanbesetfroml minute (0HR:01) upto9 hoursand 3. Oven will automatically clean for 3 hours. Press the • or
50 minutes (9 HR:50). • pad to select 2 to 4 hours. I
The timing operation will start automatically. Colon flashing "door" will appear in display until the door is properly locked.
in the display indicates a timing operation. One long See pages 20 and 21 for additional information.
continuous beep signals the end of the timing operation. The
time of day will automatically reappear in the display. The
TIMER does not control the oven.
1. Press COOK TIME pad. Enter desired cooking time with
To cancel: Press and hold TIMER pad. Time of day will the • or • pad.
reappear after a slight delay. 2. To delay the start of cooking: Press STOP TIME or OVEN r
STOP pad. Enter time you wish the oven to turn off with j
the • or • pad.
1. Press CLOCK pad. 3. Press OVEN TEMP pad. Enter oven temperature with the
2. Set the correct time of day using the • and • pads. • or • pad.
Tochange the time by one minute, press either pad once. To The oven will automatically turn on and off at the preset
change the time in increments of 10 minutes, press and times. Beeps will signal the end of cooking. Press CANCEL
pad to cancel end-of-cooking beeps. See pages 16 and 17
hold either pad. for additional information.
When power isfirst supplied to the oven or if there has been
a power failure, the display will flash.
Press CLOCK pad to recall time of day when another A beep sounds each time a pad is pressed. The oven will
function is displayed, automatically turn off if it is left on for 12 hours.If a fault code
Clock time cannot be changed when oven is set for a cook, (example: F 2) is displayed and beeps sound, press
timed bake, or self-clean operation. Cancel operation to set CANCEL pad. If fault code continues, see page 28.
the clock.
To Next Page
Loading...
Need help?
General
