Oven Door
Leveling Legs
Note: The oven door on a new range may feel "spongy"
when it is closed• This isnormal and will decrease with use.
To remove:
1. When cool, open the oven door to the first stop position
(opened about four inches).
2. Grasp door at each side. Do not use the
door handle to lift door.
3. Lift up evenly until door clears hinge
arms.
To replace:
1. Grasp door at each side.
2. Align slots in the door with the hinge arms on the range.
3. Slide the door down onto the hinge arms until the door is
completely seated on the hinges. Push down on the top
corners of the door to completely seat door on hinges. Door
should not appear crooked.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass•
2. Do not hit the glass with pots, pans, furniture, toys, or other
objects•
3. Do not close the oven door until the oven racks are in place•
Scratching, hitting, jarring or stressing the glass may weaken
itsstructure causing an increasedrisk of breakage at a later
date•
i Oven Light
To Replace Oven Light Bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
retainer off cover. NOTE: Bulb cover will fall if not held in place
while removing wire retainer.
BULB COVER
2. Removebulb coverand light bulb.
3. Replacewith a 40-wattappli-
ance bulb.
4. Replace bulb cover and se-
cure with wire retainer.
5. Reconnect power to range. Reset clock.
RETAINER
Convenience Outlet
(Canadian models only)
The convenience outlet is located on the
lower left side of the backguard. Be sure
appliance cords do not rest on or near
the surface element. If the surface
element is turned on, the cord and outlet
will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch located
on the lower edge of the backguard.
CIRCUIT BREAKER
21
To Next Page
Loading...
