11
Temperature Controls
Adjusting the Controls
• 24 hours after adding food, you may decide that one or
both compartments should be colder or warmer. If so,
adjust the control(s) as indicated in the Temperature
Control Guide table below.
• Except when starting the refrigerator, do not change either
control more than one number at a time.
• Allow 24 hours for temperatures to stabilize.
Triple Cool Climate Control
(select models)
The control is located at the top front of the fresh food
compartment.
Control
Initial Temperature Setting
Temperatures are preset at the factory at 38° F (3° C) in the
fresh food compartment and 0° F (-18° C) in the freezer
compartment.
Adjusting the Control
24 hours after adding food, you may decide that one or both
compartments should be colder or warmer. If so, adjust the
control as indicated in the Temperature Control Guide below.
•The first touch of the or pads shows the current
temperature setting.
Temperature Control Guide
Refrigerator too warm
Refrigerator too cold
Freezer too warm
Freezer too cold
Turn refrigerator OFF
Set the refrigerator control to
next higher number by
pressing the pad.
Set the refrigerator control to
next lower number by
pressing the pad.
Set the freezer control to next
higher number by pressing the
pad.
Set the freezer control to next
lower number by pressing the
pad.
Press the freezer or
refrigerator pad until a
dash “–” appears in the
display.
•The display will show the new setting for approximately three
seconds, and then return to the actual temperature currently
within that compartment.
• Do not change either control more than one degree at a time.
Allow temperature to stabilize for 24 hours before making a
new temperature adjustment.
Temperature Control Guide
Refrigerator too cold
Refrigerator too warm
Freezer too cold
Freezer too warm
Turn refrigerator OFF
Set the refrigerator control to
next higher number by
pressing the pad.
Set the refrigerator control to
next lower number by
pressing the pad.
Set the freezer control to next
higher number by pressing the
pad.
Set the freezer control to next
lower number by pressing the
pad.
Press the freezer pad
until OFF appears in the
display. Press either the
freezer or refrigerator pad
to turn back on.
Speed Ice
When activated, Speed Ice reduces the freezer temperature to
the optimum setting for 24 hours in order to produce more ice.
Note: When the Speed Ice feature is in operation, the and
pads for the freezer control will not operate.
Reset Filter (select models)
When a water filter has been installed in the refrigerator, the
yellow Order light will illuminate when 90 percent of the volume
of water for which the filter is rated has passed through the filter
OR 11 months have elapsed since the filter has been installed.
The red Replace light will illuminate when the rated volume of
water has passed through the filter OR 12 months have elapsed
since the filter was installed. A new filter should be installed
immediately when the Replace light is illuminated.
After replacing the filter, press and hold the Reset Filter pad for
three seconds. The Order and Replace lights will go off.
Vacation Mode
The Vacation Mode feature causes the freezer to defrost less
frequently, conserving energy. The Vacation Mode indicator light
To Next Page
Loading...
Need help?
General
