5-38
Driving Your Mazda
Switches and Controls
Form No. 8S06-EA-03H
The ignition switch must be in the ON
position.
▼
Rear Window Wiper
Turn the wiper on by turning the rear
wiper/washer switch.
ON
— Normal
INT
— Intermittent
▼
Rear Window Washer
To spray washer fluid, turn the rear wiper/
washer switch to the position. After
the switch is released, the washer will
stop.
If the washer doesn’t work, inspect the
fluid level (page 8-18). If it’s OK and the
washer still doesn’t work, consult an
Authorized Mazda Dealer.
The rear window defroster clears frost,
fog, and thin ice from the rear window.
The ignition switch must be in the ON
position.
Press the switch to turn on the rear
window defroster, the indicator light will
illuminate.
Press the switch again to turn it off.
Rear Window Wiper and
Washer
NOTE
There are two washer positions: up and
down. In the down washer position, the
wiper will not be activated.
OFF
ON
Washer
Washer
INT
Rear Window Defroster
Don’t use sharp instruments or
window cleaners with abrasives to
clean the inside of the rear window
surface. They may damage the
defroster grid inside the window.
NOTE
This defroster is not designed for
melting snow. If there is an
accumulation of snow on the rear
window, remove it before using the
defroster.
J16R_8S06-EA-03H_Edition1.book Page 38 Wednesday, July 9, 2003 4:19 PM
To Next Page
Loading...
