2-48
Essential Safety Equipment
Child Restraint
Form No. 8S06-EA-03H
2. If your child-restraint system requires
the use of a tether strap, peel back the
carpeting in the rear luggage
compartment to expose the anchor
bracket (above the marking).
3. Hook the tether strap by following the
child-restraint system manufacturer’s
instructions.
▼
Third-Row Outboard Seats
Child-Restraint System
Installation
The third-row outboard seats cannot
accommodate LATCH-type child-
restraint systems or tethers, therefore
these systems must be installed on the
other seat positions such as the second-
row or third-row center seat. If this not
possible, LATCH-type child-restraint
systems or tethers should be installed
using seat belts depending on whether the
child-restraint manufacturer allows their
use without LATCH attachments and
tether anchors.
Follow these instructions when using a
child-restraint system.
Marking
Anchor bracket
location
Tether
strap
Anchor
bracket
Tether strap position
Child-Restraint Tether Usage:
Using the tether or tether anchor to
secure anything but a child-restraint
system is dangerous. This could
weaken or damage the tether or tether
anchor and result in injury. Use the
tether and tether anchor only for a
child-restraint system.
NOTE
Follow the child-restraint system
manufacturer’s instructions carefully.
Depending on the type of child-
restraint system, it may not employ
seat belts which are in automatic
locking mode.
J16R_8S06-EA-03H_Edition1.book Page 48 Wednesday, July 9, 2003 4:19 PM
To Next Page
Loading...
