•
If dirt or foreign matter (Such as ice or
matter containing salt water) adheres to
the windscreen above the rain sensor or
if the windscreen is iced, it could cause
the wipers to move automatically.
However, if the wipers cannot remove
this ice, dirt or foreign matter, the
auto-wiper control will stop operation.
In this case, set the wiper lever to the
low speed position or high speed
position for manual operation, or
remove the ice, dirt or foreign matter by
hand to restore the auto-wiper
operation.
•
If the auto-wiper lever is left in the
position, the wipers could operate
automatically from the effect of strong
light sources, electromagnetic waves, or
infrared light because the rain sensor
uses an optical sensor. It is
recommended that the auto-wiper lever
be switched to the
position other
than when driving the vehicle under
rainy conditions.
•
The auto-wiper control functions can be
turned off.
Refer to Personalisation Features on
page 9-12.
:LQGVFUHHQ:DVKHU
3XOOWKHOHYHUWRZDUG\RXDQGKROGLWWR
VSUD\ZDVKHUIOXLG
Washer
OFF
NOTE
If the windscreen washer is turned on
when the windscreen wipers are not
operating, the windscreen wipers operate
a few times.
,IWKHZDVKHUGRHVQRWZRUNLQVSHFWWKH
IOXLGOHYHOSDJH,IWKHIOXLGOHYHO
LVQRUPDOFRQVXOWDQH[SHUWUHSDLUHUZH
UHFRPPHQGDQ$XWKRULVHG0D]GD
5HSDLUHU
:KHQ'ULYLQJ
6ZLWFKHVDQG&RQWUROV