EasyManua.ls Logo

Mazda CX-5 2018 - Lock Button

Mazda CX-5 2018
787 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The volume of the beep sound can also
be changed.
Refer to Personalisation Features on
page 9-12.
Use the following procedure to change the
setting.
1. Switch the ignition off and close all of
the doors and the liftgate.
2. Open the driver's door.
3. Within 30 seconds of opening the
driver's door, press and hold the LOCK
button on the key for 5 seconds or
longer.
The beep sound activates at the
currently set volume. The setting
changes each time the LOCK button on
the key is pressed and the beep sound
activates at the set volume. (If the beep
sound has been set to not activate, it
will not activate.)
4. The setting change is completed by
doing any one of the following:
Switching the ignition to ACC or
ON.
Closing the driver's door.
Opening the liftgate.
Not operating the key for ten
seconds.
Pressing any button except the
LOCK button on the key.
Pressing a request switch.
7KHRSHUDWLRQLQGLFDWRUOLJKWIODVKHVZKHQ
WKHEXWWRQVDUHSUHVVHG
/RFNEXWWRQ
7RORFNWKHGRRUVDQGWKHOLIWJDWHSUHVVWKH
ORFNEXWWRQDQGWKHKD]DUGZDUQLQJOLJKWV
ZLOOIODVKRQFH
:LWKWKHDGYDQFHGNH\OHVVIXQFWLRQ
([FHSW(XURSHDQPRGHOV
$EHHSVRXQGZLOOEHKHDUGRQFH
NOTE
(European models)
The doors and the liftgate cannot be
locked by pressing the lock button while
any other door is open. The hazard
warning lights will also not flash.
(Except European models)
The doors and the liftgate cannot be
locked by pressing the lock button while
any other door or the liftgate is open.
The hazard warning lights will also not
flash.
(With the i-stop function (European
models))
Removing the key from the vehicle,
closing all the doors and pressing the
LOCK button on the key while the i-stop
function is operating (engine is stopped)
will switch the ignition OFF and lock all
the doors (Steering wheel also locks).
Refer to i-stop on page 4-12.
Make sure all doors and the liftgate are
locked after pressing the button.
(With double locking system)
Pressing the lock button twice within
three seconds will activate the double
locking system.
Refer to Double Locking System on page
3-16.
(With theft-deterrent system)
When the doors are locked by pressing
the lock button on the key while the
theft-deterrent system is armed, the
hazard warning lights will flash once to
indicate that the system is armed.
%HIRUH'ULYLQJ
.H\V


Table of Contents