Mazda CX-7 - Programming a Bluetooth Audio Device Which Does Not Have a Four-Digit PIN Code

Black plate (303,1)
2. Press the audio control dial to
determine the mode.
After “ENTER PIN” is displayed on
the information display for two
seconds, “PIN 0000” is displayed and
the PIN code can be input.
3. Input the PIN code of your Bluetooth
®
audio device by pressing channel
preset buttons 1 to 4 while “PIN 0000”
is displayed.
Press channel preset button 1 to input
the first digit, 2 for the second, 3 for
the third, and 4 for the forth. For
example, if the PIN code were “4213”,
press channel preset button 1 four
times (1, 2, 3, 4), button 2 twice (1, 2),
button 3 once (1), and button 4 three
times (1, 2, 3). If the “PIN 0000”
display disappears before finishing the
PIN code input, repeat the procedure
from Step 1.
NOTE
Some devices accept only a particular pairing
code (Usually, “0000” or “1234”).
If pairing cannot be completed, refer to the
owner's manual of your mobile device, and try
those numbers if necessary.
4. Press the audio control dial while the
input PIN code is displayed.
“PAIRING” flashes on the display.
5. Operate the Bluetooth
®
audio device
and set it to the program mode while
“PAIRING” is flashing.
6. When the programming is completed,
“
” and “PAIR SUCCESS” are
displayed after about 10-30 seconds,
after which “PAIR SUCCESS”
continues to be displayed for three
seconds, and then the unit returns to the
normal display.
NOTE
l
Some Bluetooth
®
audio devices need a
certain amount of time before the “
”
symbol is displayed.
l
If the programming failed, “Err” flashes
for three seconds then it returns to the
normal display.
l
Programming cannot be performed while
the vehicle is moving. If you attempt to
perform programming while the vehicle is
moving, “PAIR DISABLE” is displayed and
it returns to the normal display.
l
If seven Bluetooth
®
audio devices have
already been programmed to the vehicle,
programming cannot be performed and
“MEMORY FULL” is displayed. Delete
one programmed device to program
another one.
Programming a Bluetooth
®
audio
device which does not have a four-digit
PIN code
1. Using the audio control dial, select the
pairing program mode
“PAIR DEVICE” in the “BT SETUP”
mode. (Refer to “Bluetooth
®
audio set
up” for details.)
2. Press the audio control dial to
determine the mode.
After “ENTER PIN” is displayed on
the information display for two
seconds, “PIN 0000” is displayed and
the PIN code can be input.
3. Press the audio control dial while
“PIN 0000” is displayed.
“PAIRING” flashes on the display.
4. Operate the Bluetooth
®
audio device
and set it to the program mode while
“PAIRING” is flashing.
5. As the Bluetooth
®
audio device
requires a PIN code, input “0000”.
Interior Comfort
Bluetooth® Audio
6-65
CX-7_8CG3-EA-11J_Edition1 Page303
Saturday, September 24 2011 10:33 AM
Form No.8CG3-EA-11J