® J94S.book Page 6 Saturday, June 23, 2001 1:04 PM
In Case of an Emergency
Flat Tire
▼ Removing a Flat Tire
1. Pry off the wheel cover with the
beveled end of the lug wrench.
& CAUTION
Align the notch on the wheel cover
with the valve stem when installing it.
Damage could occur during
installation if the wheel cover is not
properly aligned.
2. Loosen the lug nuts by turning them
counterclockwise one turn each, but
don’t remove any until the tire has been
raised off the ground.
3. Place the jack under the jacking
position closest to the tire being
changed.
■&
7-6
t
Form No. 8Q50-EA-01G
To Next Page
Loading...
