J94S.book Page 11 Saturday, June 23, 2001 1:04 PM
Driving Your Mazda
Starting and Driving
▼ Overdrive
O verdrive operation
In D, the transaxle automatically shifts to
overdrive, which improves fuel economy
and reduces noise.
To allow engine braking when going
down a steep grade, make sure the
overdrive button is in the off position.
And for a smoother ride with less shifting,
don’t use it when:
• Going up a steep grade.
• Driving in stop-and-go traffic.
• Pulling heavy loads.
To tu rn off the overdrive, push the
button.
The transaxle will then shift through a
three-gear sequence in D.
Shift patterns without overdrive:
To tu rn it on, push the b utton again.
Shift patterns with overdrive:
D 1st, 2nd, 3rd, 4th
2
Without Traction
Control System
2nd
With Traction
Control System
1st, 2nd
1 1st
O/D O FF indicator light
0/D
OFF
This light comes on when the overdrive
has been turned off.
A CAUTION
If the overdrive-off indicator light
flashes, the transaxle has an electrical
problem. Continuing to drive your
Mazda in this condition could cause
damage to your transaxle. Consult an
Authorized Mazda Dealer as soon as
possible.
D 1st, 2nd, 3rd
2
Without Traction
Control System
2nd
With Traction
Control System
1st, 2nd
1 1st
5-11
Form No. 8Q50-EA-01G
To Next Page
Loading...
