J94S.book Page 3 Saturday, June 23, 2001 1:04 PM
Driving Your Mazda
Starting and Driving
NOTE
If turning the key is difficult, jiggle the
steering wheel from side to side.
ACC (Accessory)
The steering wheel unlocks and some
electrical accessories will operate.
ON
This is the normal running position after
the engine is started. The warning lights
(except brakes)should be inspected before
the engine is started (page 5-23).
START
The engine is started in this position. It
will crank until you release the key; then
it returns to the ON position. The brake
warning light can be checked after the
engine is started (page 5-23).
▼ Ignition Key Reminder
If the ignition switch is in the LOCK or
ACC position, a beep will sound when
any door is opened.
Starting the Engine
NOTE
Engine-starting is controlled by the
spark ignition system.
This system meets all Canadian
Interference-Causing Equipment
Standard requirements regulating the
impulse electrical field strength of
radio noise.
1. Occupants should fasten their seat
belts.
2. M ake sure the parking brake is on.
3. Depress the brake pedal.
4. (M anual transaxle)
Depress the clutch pedal all the way
and shift into neutral.
Keep the pedal depressed while
cranking the engine.
The starter w ill not operate if the
clutch pedal is not pushed down all the
way.
5-3
Form No. 8Q50-EA-01G
To Next Page
Loading...
