J94S.book Page 4 Saturday, June 23, 2001 1:04 PM
Essential Safety Equipment
Seats
To change the seatback angle, lean
forward slightly while raising the lever.
Then lean back to the desired position and
release the lever.
Make sure the lever returns to its original
position and the seatback is locked in
place by attempting to push it forward and
backward.
/h CAUTION
W hen returning a rear-reclined
seatback to its upright position, make
sure you support the seatback while
operating the seatback lever. If the
seatback is not supported, it will flip
forward suddenly and could cause
injury.
▼ Seat Tilt (Driver’s Seat)
(M anually op erated model)
The seat-bottom angle can be adjusted by
rotating the dial.
(Electrically operated m odel)
F ront height adjustm ent
To adjust the front height of the seat-
bottom, raise or lower the front of the
slide lifter switch on the left side of the
seat.
2-4
&
Form No. 8Q50-EA-01G
To Next Page
Loading...
