J94S.book Page 22 Saturday, June 23, 2001 1:04 PM
Essential Safety Equipment
Child Restraint
3. Push the child-restraint system firmly
into the vehicle seat. Be sure the belt
retracts as snugly as possible. Clicking
from the retractor will be heard during
retraction if the system is in the
automatic locking mode. If the belt
does not lock the seat down tight,
repeat this step.
NOTE
Inspect this function before each use of
the child-restraint system. You should
not be able to pull the shoulder belt out
of the retractor while the system is in
the automatic locking mode. When
you remove the child-restraint system,
be sure the belt fully retracts to return
the system to emergency locking mode
before occupants use the seat belts.
2-22
4. If your child-restraint system requires
the use of a tether strap, hook and
tighten the tether strap by following the
manufacturer’s instructions.
Tether
strap
& WARNING
Child-Restraint Tether Usage:
Using the tether to secure anything
but a child-restraint system is
dangerous. This could weaken or
dam age the tether or tether anchor
and result in injury. Use the tether
and tether anchor only fo r a child-
restraint system.
Form No. 8Q50-EA-01G
To Next Page
Loading...
