MB Connect Line mbNET.mini Series User Manual

17
Transfer conguration to the mbNET.mini
When the mbNET.mini is ready to operate, insert the USB stick
into the USB port of the device.
The device will recognize the conguration le and show that th-
rough the slowly ashing LED Usr (ashing frequency: 1.5 Hz).
If the ashing frequency of the LED Con is 3 Hz, the device is attempting to log into the portal. If
the login has been successful, the ashing frequency is reduced to 1.5 Hz.
When the LED Usr goes o󰀨 and the LED Pwr
+ Rdy light up, then the conguration transfer
is complete.
When the mbNET.mini can connect to the Internet
(e.g. network cable, SIM card, antennae installed),
the device will subsequently log in to your account.
This is displayed by the ashing LED Con.
As soon as the LED Usr starts to ash
,
you must press the Function button within
10 seconds.
Hold down until the LED Usr lights.
Now release the Function button
.
Pwr
Rdy
Con
Usr
Pwr
Rdy
Con
Usr


Pwr
Rdy
Con
Usr
Pwr
Rdy
Con
Usr

MB Connect Line mbNET.mini Series Specifications

General

Brand	MB Connect Line
Model	mbNET.mini Series
Category	Network Router
Language	English