FleX Controller – User Manual 17
Version 1.0
A normal boot up sequence is as follows:
U-Boot 1.3.0-rc2 (Aug 19 2016 - 11:08:28) McCainEngineBoard
Reset Status: Software Hard, External/Internal Soft, External/Internal Hard
CPU: e300c1, MPC8360E, Rev: 21 at 399.999 MHz, CSB: 266 MHz
Unit: McCain Engine Board III
testing for ATCeX2, ATCeXRM and 2070-1C
I2C: ready
DRAM: 256 MB
FLASH: 16 MB
NAND: 256 MiB
In: serial
Out: serial
Err: serial
Net: UEC: PHY is Generic MII (0)
UEC: PHY is Generic MII (0)
FSL UEC0, FSL UEC1
Hit any key to stop autoboot: 0
## Booting image at fe100000 ...
Image Name: mgr Image
Image Type: PowerPC Linux Kernel Image (uncompressed)
Data Size: 5717472 Bytes = 5.5 MB
Load Address: 00000000
Entry Point: 00010000
OK
Booting using the fdt at 0xfe0f0000
Loading Device Tree to 007fc000, end 007fefff ... OK
Using MPC836x MDS machine description
Linux version 2.6.39.4mau (mguerrero@MGUERRERO) (gcc version 4.1.2 (Sourcery G++ Lite
4.1-69)) #81 Wed Feb 8 11:48:40 PST 2017
bootconsole [udbg0] enabled
setup_arch: bootmem
mpc836x_mds_setup_arch()
arch: exit
Zone PFN ranges:
DMA 0x00000000 -> 0x00010000
Normal empty
Movable zone start PFN for each node
early_node_map[1] active PFN ranges
0: 0x00000000 -> 0x00010000
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 65024
Kernel command line: root=/dev/mtdblock4 rootfstype=jffs2 rw console=ttyS0,115200
PID hash table entries: 1024 (order: 0, 4096 bytes)
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 254212k/262144k available (4168k kernel code, 7932k reserved, 176k data, 1251k
bss, 184k init)
Kernel virtual memory layout:
* 0xfffdf000..0xfffff000 : fixmap
* 0xfdef1000..0xfe000000 : early ioremap
* 0xd1000000..0xfdef1000 : vmalloc & ioremap
NR_IRQS:512
IPIC (128 IRQ sources) at d1000700
clocksource: timebase mult[3c00001] shift[22] registered
To Next Page
Loading...
