18 – English
Driving
6 Move the throttle in between positions 1 and 2.
7 Turn the ignition key to the start position.
8 When the engine starts release the ignition key
immediately back to neutral position.
9 Move the throttle backwards gradually once the engine
has started. Let the engine run at moderate speed or half
throttle for 3-5 minutes before subjecting it to heavy load.
10 Set the required engine speed with the throttle control.
Starting the engine with a weak
battery
If the battery is too weak to start the engine, it should be
recharged. Charge the battery for 4 hours at max. 3 amp.
When jump leads are used for emergency starting, follow the
procedure below:
Connecting the jump leads
• Connect each end of the red cable to the POSITIVE pole
(+) on each battery, exercise care not to short circuit any
of the ends against the chassis.
Connect one end of the black cable to the NEGATIVE pole
(-) on the fully charged battery.
• Connect the other end of the black cable to a good
CHASSIS EARTH, away from the fuel tank and the
battery.
Remove the cables in the reverse order
• The BLACK cable is removed from the chassis and then
the fully charged battery.
• Finally the RED cable from both batteries.
Driving the Rider
1 Release the parking brake.
M105-85F
Release the parking brake by first pressing down the
parking brake pedal and then releasing it.
M125-85FH
Release the parking brake by moving the lever
backwards.
2 M105-85F
Disengage the engine and select the required gear.
Gradually release the clutch pedal.
IMPORTANT INFORMATION
If the engine does not start wait about 1 minute before trying
again.
To Next Page